Puffer

LCD bridge

Firmware 0.18 for the PanelLan 2.8" panel. This board has no over-the-air updates, so every update is installed here over USB.

  1. Plug the bridge into this computer with a USB-C data cable.
  2. Press Install and pick the port named “USB JTAG/serial debug unit”.
  3. Leave “Erase device” off to keep its Wi-Fi, Proxy and dock pairing.

This browser has no Web Serial. Open this page in Chrome or Edge on a computer.

Web Serial needs a secure page. Open this site over HTTPS.

If the install cannot connect, pull GPIO0 low on the DEBUG header while tapping RESET, then try again. Only this board: the image will not run on the XIAO bridge or the dock.